This is a general OLED display Module, 1.5inch diagonal, 128x128 pixels, 16 gray scale, with embedded controller, communicating via SPI or I2C interface.
Features:
- 128x128 high resolution
- 16 gray scale, better display effect
- Supports SPI or I2C interface, configured via onboard resistor
- Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Specifications:
- Driver: SSD1327
- Interface: SPI / I2C
- Display color: White
- Gray scale: 16
- Resolution: 128x128 (most other competitive products are typically 128x64)
- Viewing angle: >160°
- Operating voltage: 3.3V / 5V
- Dimension: 44.5 x 37 (mm)
Interface:
| SYMBOL |
DESCRIPTION |
| VCC |
Power (3.3~5V input) |
| GND |
Ground |
| DIN |
Data input |
| CLK |
Clock data input |
| CS |
Chip selection, low active |
| DC |
Data/Command selection (high for data, low for command) |
| RST |
Reset, low active |
There are two available drive interfaces for this OLED module: 4-wire SPI and I2C:
| |
BS |
CS |
DC |
DIN |
CLK |
| 4-wire SPI |
0 |
Chip select |
Data/Command |
MOSI |
SCK |
| I2C |
1 |
NC |
I2C address selection |
SDA |
SCL |
Dimensions:
Documents:
EN
